UTC-EVO

Manufacturer Pike Signals Limited
Specification TOPAS 2502B under review

More Info

TOPAS Re-Registration 3/7/20    Certificate 2020/0168

Exceptions : In respect of TOPAS 2502B,  TOPAS 2538B and TOPAS 2537A

SA/SD  Equipment: (TOPAS 2537A clause 2.58 & TOPAS 2338A clause 2.57)  This function is not included with this eqiupment.

Cat 1 Failure mode: (TOPAS 2502B clause 2.60, TOPAS 2537A clause 2.71 and TOPAS 2538A clause 2.70): Note : rather than transition immediately to all red, the system enters a HOLD state in which no signalling transitions can occur.  This lasts for up to 12 seconds, during which time the system works to find a viable alternative radio channel on which to resume operation, in the event that this operation is unsuccessful, the system transitions to immediate lights out state

Vehicle to Pedestrian Intergreen: (TOPAS 2537A clause 2.4): Controllers will run preceding vehicle all red time, prior to pedestrian green.  A minimum of 3 second all red period will be achieved.

Pedestrian Green Time: (TOPAS 2537A clause 2.42 and TOPAS 2538A clause 2.39): The controllers offer alternative pedestrian green times, always with a minimum of 7 seconds.

Automatic Comms Recovery: (TOPAS 2502B clause 2.61;  TOPAS 2537A clauses 2.72 and TOPAS 2538A clause 2.71): Following a CAT1 fault, the system waits for a variable hold-off period before then automatically attempting to restart the system through the safe start-up sequence.  The hold off period starts at 5 seconds then increases to 1 minute, then 2, 5, 15,30 in the event that subsequent attempts to restart are not successful. 

Minimum Green Time : (TOPAS 2502B clause 2.28;  TOPAS 2537A clause 2.31; TOPAS 2538A clause 2.29) The minimum green time employed when operating in Vehicle Actuation mode is 12 seconds but is automatically reduced to a value between 6 and 12 seconds in cases where the maximum green time is set by the operative to a value of 15 seconds or less.

Red Times (TOPAS 2537A clause 2.32) All-red times are selectable in one second increments

Maximum Green Times : (TOPAS 2502B clause 2.34;  TOPAS 2537A clause 2.39; TOPAS 2538A clause 2.36) Maximum green times are selectable between 6 seconds and 60 seconds in 1 second increments.  A 'hidden' function is available to advanced users (under highway authority instruction) in order to allow maximum green times in the range of 6 - 15 seconds to be set.

CAT 3 fault : (TOPAS 2502B clause 2.62; TOPAS 2537A clause 2.73: TOPAS 2538A clause 2.72) When a CAT 3 fault occurs, all signal heads in the system automatically complete any amber transition currently in progress

 

---

 

 

TOPAS First Registration 14/8/15  Certificate Number 2015/0092

 

HA Approval 16/7/15 under TR2502B; TR2538A; TR2537A

Contact Details

Union House, 111 Union Street, Coventry CV1 2NT
T: ##### ######
F: ##### ######
E: Email